SSR4 DMX ONLY Manual
Adding the optional DMX to the SSR4
Step 1
Open your bag of DMX parts and find the chip sockets. You should have no problem finding the location for these on the board so make sure to put them in the correct direction and solder them in.
Now find the 120 ohm resistor and locate it place between the locations for the two RJ45 jacks and install it.
Find the 22K resistor and install it in its place between the two 6 pin sockets.
Install the two large 15K resistors in their place above the fuse. You will stand these up as in the picture. Make sure they do not touch anything else as they carry 120 volts when live.
Install the one .1 uf cap next to the large socket.
Step 2
Install the two capacitors (680uf & 100uf) just above the large 15K resistors.
Install the 7805 5 volt regulator to the right of them with the metal side facing the capacitors.
Install the 2 terminal pin jumper in the location marked TERM. And the 3 terminal pin jumper in the location marked operate/program.
Install the second RJ45 jack in its location.
Step 3
Install the Transformer on the board. It will only fit one way and you can ignore the markings under it as they are for optional parts for non 120 volt operation.
Now we need to put the chips in. As before take your time. There are two 6 pin chips make sure the one with the + - on the top of it is put near the Transformer and the + - side is lined up with the + - markings on the pcb.
Make sure these chips are inserted in the correct direction. Now set you jumpers as shown above to make it a Controller.
BE SAFE!
Thank you, enjoy your Controller and
MAY GOD BLESS YOU IN ALL YOU DO!
