Difference between revisions of "Troubleshooting Lynx Dongle"
From DiyLightAnimation
(New page: ==My Lynx Dongle is not working.== ::# Make sure that your PIC is programmed with the proper firmware. ::# If you have a PIC programmer, you can program it yourself with the [[Equipme...) |
|||
| Line 13: | Line 13: | ||
::# Try changing USB cables. | ::# Try changing USB cables. | ||
::# There was one report of at least one bad FTDI USB module. | ::# There was one report of at least one bad FTDI USB module. | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | [[Category:Help|{{PAGENAME}}]] | ||
Latest revision as of 07:48, 29 August 2009
My Lynx Dongle is not working.
- Make sure that your PIC is programmed with the proper firmware.
- If you have a PIC programmer, you can program it yourself with the latest firmware.
- If you do not have a programmer, find someone to help program your dongle PIC.
My Lynx Dongle is not getting detected by windows.
- Check all of your solder joints again.
- Do you have the FTDI Drivers installed?
- Try changing USB cables.
- There was one report of at least one bad FTDI USB module.
