Pixelnet EtherDongle
- Checksum
- Pickit3 - xxxx
- Checksum
- Pickit3 - xxxx
NOTE: Only use the Pickit 3 utility and not MPLAB to program the firmware
NOTE: DON'T USE THE 49.9K RESISTORS FROM THE FIRST COOP, RJ IS GETTING REPLACEMENTS. THEY SHOULD BE 49.9 OHM
|
Lynx Conductor
EtherDongle Daughter Board
- Checksum
- Pickit3 - xxxx
Lynx Trigger
Conductor Input Board
|
Lynx Slave
EtherDongle Daughter Board
|
PixelNet 16 Port Active Hub
- Checksums
- Pickit2 - 811E
- Pickit3 - 8196
NOTE: Only use the Pickit (2 or 3) utility and not MPLAB to program the firmware
NOTE: POWER CONNECTORS: ALWAYS use the (3) 4 pin power connectors with the 24 pin connector
- Failure to add the extra power connectors can/will damaged the PS 24 pin Connector and Hub from excess current
|
Pixelnet 16 Port Passive Hub
NOTE: POWER CONNECTORS: ALWAYS use the (3) 4 pin power connectors with the 24 pin connector
- Failure to add the extra power connectors can/will damaged the PS 24 pin Connector and Hub from excess current
|
Pixelnet 4 Port Passive Hub
|
Smart String Controller
- Checksums
- Pickit2 - E2EB
- Pickit3 - E363
- Checksums
- Pickit2 - 2EF2
- Pickit3 - 2F6A
NOTE: Only use the Pickit (2 or 3) utility and not MPLAB to program the firmware
To configure SSC SS Utility
|
Smart String Controller V2
- Checksums
- Pickit2 - 19F3
- Pickit3 - 1A6B
NOTE: Only use the Pickit (2 or 3) utility and not MPLAB to program the firmware
To configure SSC SS Utility
|
Dumb String Controller
- Checksums
- Pickit2 - xxxx
- Pickit3 - xxxx
NOTE: Only use the Pickit (2 or 3) utility and not MPLAB to program the firmware
|
Pixelnet USB Dongle
- NOTE: Not for use with DMX, See below for DMX firmware
- Checksums
- Pickit2 - 613B
- Pickit3 - 613B
NOTE: Only use the Pickit (2 or 3) utility and not MPLAB to program the firmware
Put one of the files below in the Vixen /plugin/output folder
|
Lynx Combiner
|