Difference between revisions of "Equipment Errata"
From DiyLightAnimation
| Line 18: | Line 18: | ||
* First run pcbs marked ver 1.0 | * First run pcbs marked ver 1.0 | ||
* Missing trace for channel 4 | * Missing trace for channel 4 | ||
| − | + | A jumper on the forth RS485 (channel 4) is necessary to enable 1 in / 4 out operation. Without the jumper, only three of the outputs are active. | |
* Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332 | * Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332 | ||
Revision as of 14:09, 13 April 2009
This page is for mods need on released production boards from DLA. Normally the mods are only needed for ver 1.0 of the boards. If you don't see a board listed here then most likely there is none needed.
Freestyle
- First run pcbs marked ver 1.0
- Missing trace for channel 49
- Add wire jumper as shown in the picture below
SSR4
- First run pcbs marked ver 1.0
- Only need for SSR4 with DMX option on it.
- RJ-45 trace issues.
- Cut the 4 traces as shown in the pictures below
Splitter
- First run pcbs marked ver 1.0
- Missing trace for channel 4
A jumper on the forth RS485 (channel 4) is necessary to enable 1 in / 4 out operation. Without the jumper, only three of the outputs are active.
- Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332
