Difference between revisions of "Equipment Errata"
From DiyLightAnimation
| Line 19: | Line 19: | ||
* Missing trace for channel 4 | * Missing trace for channel 4 | ||
If you do not add a jumper on the forth RS485 then you will have 1 input and three DMX out instead of four. You can leave it and not populate the forth RS485 chip and socket and use it with 1 in / 3 out or you can add the jumper and have 1 in / 4 out. | If you do not add a jumper on the forth RS485 then you will have 1 input and three DMX out instead of four. You can leave it and not populate the forth RS485 chip and socket and use it with 1 in / 3 out or you can add the jumper and have 1 in / 4 out. | ||
| − | * Add wire jumper as shown | + | * Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332 |
[[Category:Hardware]] | [[Category:Hardware]] | ||
[[Category:Equipment]] | [[Category:Equipment]] | ||
[[Category:Errata]] | [[Category:Errata]] | ||
Revision as of 12:04, 13 April 2009
This page is for mods need on released production boards from DLA. Normally the mods are only needed for ver 1.0 of the boards. If you don't see a board listed here then most likely there is none needed.
Freestyle
- First run pcbs marked ver 1.0
- Missing trace for channel 49
- Add wire jumper as shown in the picture below
SSR4
- First run pcbs marked ver 1.0
- Only need for SSR4 with DMX option on it.
- RJ-45 trace issues.
- Cut the 4 traces as shown in the pictures below
Splitter
- First run pcbs marked ver 1.0
- Missing trace for channel 4
If you do not add a jumper on the forth RS485 then you will have 1 input and three DMX out instead of four. You can leave it and not populate the forth RS485 chip and socket and use it with 1 in / 3 out or you can add the jumper and have 1 in / 4 out.
- Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332
