Equipment Errata
From DiyLightAnimation
This page is for mods need on released production boards from DLA. Normally the mods are only needed for ver 1.0 of the boards. If you don't see a board listed here then most likely there is none needed.
Freestyle
- First run pcbs marked ver 1.0
- Missing trace for channel 49
- Add wire jumper as shown in the picture below
SSR4
- First run pcbs marked ver 1.0
- Only need for SSR4 with DMX option on it.
- RJ-45 trace issues.
- Cut the 4 traces as shown in the pictures below
Splitter
- First run pcbs marked ver 1.0
- Missing trace for channel 4
A jumper on the forth RS485 (channel 4) is necessary to enable 1 in / 4 out operation. Without the jumper, only three of the outputs are active.
- Add wire jumper as shown http://diylightanimation.com/index.php?action=dlattach;topic=360.0;attach=332
