Difference between revisions of "Enttec Pro Connections"
From DiyLightAnimation
Aussiephil (Talk | contribs) (New page: Based on a question from the forums *I'm at a roadblock!! Got my first of four Lynx built, I have my Pro dongle, but thats where the pavement ends.. Can someone post how does the Pro get...) |
(No difference)
|
Revision as of 09:39, 23 April 2008
Based on a question from the forums
- I'm at a roadblock!! Got my first of four Lynx built, I have my Pro dongle, but thats where the pavement ends.. Can someone post how does the Pro get wired? The Lynx manual says Lynx Cat5 pins 1, 2 get wired to DMX's pins 2, 3.. well, I identified pins 2, 3 on the DMX Pro, but which jack, the DMX IN or OUT? On the Cat5 cable, which are pins 1, 2? Can someone ID Cat5 pins 1, 2 by the color pairs? Pictures.. anyone got pictures of theirs?
The |Datasheet for the Prois at the Enttec website
This Website shows the pinouts for the 5 pin XLR
For CAT 5 Pinouts Wikipedia has a great little article and pictures.
From the Enttec Pro Dongle you would use the Out connector, the input is optional use.
