Difference between revisions of "Template:Set Address"
m |
|||
| Line 3: | Line 3: | ||
Step 1 - '''Turn off power to controller and move jumper to program mode''' | Step 1 - '''Turn off power to controller and move jumper to program mode''' | ||
| − | Step 2 - '''Run RJ's Lynx Address Program and select address you need. Click on Program button''' [http://diylightanimation.com/index.php?action=dlattach;topic= | + | Step 2 - '''Run RJ's Lynx Address Program and select address you need. Click on Program button''' [http://diylightanimation.com/index.php?action=dlattach;topic=2676.0;attach=2607 Click here to download if needed, Lynx Address Utility] |
Step 3 - '''Turn on controller and count to 5''' | Step 3 - '''Turn on controller and count to 5''' | ||
Revision as of 17:06, 30 May 2011
To program the Lynx Controller/Dimmer.
Step 1 - Turn off power to controller and move jumper to program mode
Step 2 - Run RJ's Lynx Address Program and select address you need. Click on Program button Click here to download if needed, Lynx Address Utility
Step 3 - Turn on controller and count to 5
Step 4 - Turn off controller and move jumper back to operation mode
Step 5 - Click Stop on the Lynx Address Program
Step 6 - Turn on controller and use your selected program to see if controller is now on the correct start address.
Either exit Lynx Address Program or go back to step 1 to program another controller
OPTIONAL Way if the above doesn't work - From RJ
Step 1 - Start with the SSR4.
Step 2 - Turn it on and using my address utility start it sending the address you want out.
Step 3 - With the SSR4 still powered carefully move the jumper.
Step 4 - Count to 3 seconds.
Step 5 - pull the plug on the SSR4.
Step 6 - put the jumper back to operate and power it back up.
