Difference between revisions of "Equipment"
From DiyLightAnimation
m (→'''Dimmers''': LE - Update firmware file and checksum) |
(Add Aether) |
||
| Line 83: | Line 83: | ||
::One DMX output (DMX Out2) if using the mounted EX/RX wireless module on ver 3 pcb and higher | ::One DMX output (DMX Out2) if using the mounted EX/RX wireless module on ver 3 pcb and higher | ||
:<nowiki>***</nowiki> MR16 is capable of handling up to 24 volt DC source power. Please place a heat sink on the 5 volt regulator. | :<nowiki>***</nowiki> MR16 is capable of handling up to 24 volt DC source power. Please place a heat sink on the 5 volt regulator. | ||
| + | |||
| + | =='''Aether'''== | ||
| + | '''DMX LED RGB(W) Flood/Spot Light''' | ||
| + | {| {{Prettytable}} cellpadding="15" cellspacing="0" border="1" | ||
| + | |||
| + | |<center>'''Lynx Aether'''</center>[[Image:|left|thumb|160px|16 Channel]] | ||
| + | *[[Manual]] | ||
| + | *[http://www.vimeo.com/11860195| Part 1 Video Manual] | ||
| + | *[http://www.vimeo.com/11917519| Part 2 Video Manual] | ||
| + | *[http://www.vimeo.com/11934893| Part 3 Video Manual] | ||
| + | *[[BOM]] or [ Mouser Direct] | ||
| + | *[[Graphics]] | ||
| + | *[ Firmware] xxxx | ||
| + | |- | ||
| + | |} | ||
| + | ---- | ||
{| {{Prettytable}} cellpadding="15" cellspacing="0" border="1" | {| {{Prettytable}} cellpadding="15" cellspacing="0" border="1" | ||
Revision as of 16:05, 22 May 2010
Contents
Hooking up a DMX Universe
- Hookup Diagrams showing DMX devices connected to a computer.
Equipment Errata
- This page is for mods needed on released production boards from DLA.
Controller (Dimmers) Comparison Table
| Controller | DMX | # Channels | On Board SSR | Wireless Pkg | LNT | Dimming | On Board Splitter | 12v DC | 120v AC | 240 AC |
| Lynx Express | Yes | 16 | Yes | EX/RX or RX | Yes | Yes | Yes (1)** | No | Yes | Yes |
| Lynx Freestyle | Yes | 128 | No/SSR4 | EX/RX wMod or RX | No | Yes | No | No | Yes | Yes |
| Lynx SSR4-DMX | Yes | 4 | Yes | EX/RX wMod or RX | No | Yes | No | No | Yes | No |
| Lynx MR-16 | Yes | 16 | LED/MR16 | EX/RX wMod or RX | No | Yes | No | Yes *** | No | No |
- Legend
- LNT = Light Normalizing Technology. With the proper curves all lights turn on and dim at the same rate.
- Need to know if Lynx hardware works in your region? Lynx Voltage Info
- Asterisk Notes
- ** Two DMX outputs using wired input (Cat5) with ver 3 pcb and higher or
- One DMX output (DMX Out2) if using the mounted EX/RX wireless module on ver 3 pcb and higher
- *** MR16 is capable of handling up to 24 volt DC source power. Please place a heat sink on the 5 volt regulator.
Aether
DMX LED RGB(W) Flood/Spot Light
|
|
|
|
 |
 |
 |
 |
 |
 |
 |
|
|
